Server Technology C-16HF1-C20 Metered ATS Specifications:
Input Connector - (2) IEC C20
Input Cords - Sold separately (PTCord-1)
Input Current Rating - ≤ 16A (20A max)
Input Voltage Rating - 100V-120V L-N nominal, 60Hz
Outlets - (16) NEMA 5-20R
Output Current Rating - ≤ 16A (20A max)
Output Usable Power - 1.9kW
Output Max Power - 2.4kW @ 120V
Type - Metered (Not Networked)
Input Current Monitoring - Yes
Form Factor - 2U, Horizontal Mount (Brackets Included)
Branch Circuit Protection - Internally fused
Input Current LEDs - One per input feed
Expansion Unit to Share One IP Address - NA
Temperature/Humidity Sensors - No
Phase Synchronization Required? - No
2U (3.48"H) x 17.2"W x 14.13"D
The Server Technology C-16HF1 Fail-Safe Transfer Switch (FSTS) provides fail-over redundancy to single or dual power supply servers and network devices. Exclusive to the Fail-Safe Transfer Switch is its ability to carry loads on both the A and B circuits during normal operation.
Unlike a common automatic transfer switch, the Fail-Safe unit is unique in that the "A" in-feed routinely powers half the outlets, and the "B" in-feed routinely powers the other half. However, if either in-feed goes down, the other powers all outlets. This "Fail-Safe" method has several advantages compared to a standard ATS. A standard ATS contains two-in-feeds, but runs all outlets from just one source, with the secondary source only being used once an outage occurs. The Server Technology design does not prohibit load balancing between the two supplied circuits which results in less heat and a lower voltage drop compared to the same load existing on just one source. Only when an outage occurs on one of the two sources will the entire load be applied to a single source. 19" rack brackets included.
Metered (not networked)
Digital True RMS input current at ±10% and 0.1 amp resolution (to 9.9 amps measurement, 1 amp at > 10 amp).
Power transfer in 10-16 milliseconds maximum
Dual Power Source Input
Each input supplies power to half of the outlets
Input power cables for NEMA L5-30P, L6-30P, IEC 60390/C19
Inputs must have same voltage
Monitor load per circuit
Transfer Switch is compatible with a UPS that provides a sin wave AC output waveform.
Operating: 32° to 104°F (0° to 40°C) Temperature - 8% to 90% non-condensing Humidity
Storage: -40° to 185°F (-40° to 85°C) Temperature - 8% to 90% non-condensing Humidity
cTUVus – UL 60950-1:2007
CAN/CSA 22.2 No. 60950-1-07
FCC Class A, Part 15
Branch Circuit Protection
Compliant to UL 60905-1
UL248 listed fuses, 20A
Two (2) branches per input
Current Rating: <16A; Interrupt rated at 100kAIC
Server Technology offers a standard 2-year limited parts & labor warranty. Extended support is available at the time of purchase.